Auto Specialties recommends these pulleys be installed by a qualified mechanic.

1. PLACE BLOCKS BEHIND REAR TIRESS TO PREVENT CAR FROM ROLLING BACK. JACK UP VEHICLE AND REMOVE RIGHT FRONT TIRE.

2. REMOVE 2 PLASTIC SNAP PLUGS FROM PLASTIC INNER FENDERWELL. THIS ALLOWS MOVEMENT FOR EASIER ACCESS.

3. REMOVE CRANKSHAFT BOLT USING AN IMPACT AND 19MM SOCKET. THIS IS DONE FROM THE INNER FENDERWELL.

4. REMOVE ALTERNATOR NUT WITH IMPACT AND 15/16 SOCKET.

5. LOOSEN FOUR WATER PUMP PULLEY BOLTS.

6. LOOSEN TENSIONER(S) USING 14MM WRENCH ON PULLEY NUTS. DO NOT REMOVE THE NUTS. YOU WILL HAVE BETTER ACCESS FROM THE BOTTOM.

7. USE 5MM ALLEN WRENCH OR SOCKET TO LOOSEN TENSIONER ADJUSTMENT FOR BELT REMOVAL.

8. REMOVE STRUT FOR ACCESS TO INNER BELT. IT IS EASIEST TO REMOVE STRUTS UPPER BRACKET BY REMOVING (2) 13MM BOLTS. LEAVING THE BRACKET ATTACHED TO THE STRUT.

9. LOOSEN POWER STEERING BOLT WITH WRENCH. IF BOLT CAN'T BE LOOSENED YOU WILL HAVE TO DO THE FOLLOWING: LOOSEN POWER STEERING FROM BRACKETS. DO NOT DISCONNECT HOSES. SWING POWER STEERING UP AND LOOSEN & REMOVE BOLT WITH WRENCH. AN AIR IMPACT WRENCH MAYBE REQUIRED TO REMOVE BOLT. THEN REMOVE POWER STEERING PULLEY.

10. AT THIS POINT REMOVE CRANK, WATER PUMP AND ALTERNATOR PULLEY. INSTALL NEW CRANK, WATER PUMP, ALTERNATOR AND POWER STEERING PULLEY. ASP RECOMMENDS PUTTING LOCTITE 242 (OR EQUIVALENT) ON THREADS TO SECURE BOLTS. TORQUE BOLTS TO FACTORY SPECIFICATIONS. REPLACE INNER BELT WITH GATES BELT K040490. REPLACE OUTER BELT WITH GATES BELT K060427.

11. REVERSE INSTRUCTIONS FOR REASSEMBLY. INSPECT BELT FOR PROPER SEATING. CRANK UP ENGINE AND INSPECT FOR ANY PULLEY WOBBLE.